BACK

FMAG-I Insertion

 
Overview
  • FMAG-I is used to measure the volumetric flow of conductive fluid in closed pipelines;
  • FMAG-I is suitable for DN50~DN3000 pipeline;
  • The conductivity of fluid media should not be less than 20μS / cm;
  • Changes in pressure, temperature, density and viscosity do not affect the flow measurement of FMAG-I;
  • A small amount of solid particles or bubbles in the fluid can also be measured;
  • The fixed-length installation type has a simple structure, commissioning and maintenance;
  • FMAG-I can be easily installed and removed without stopping water under low pressure;
  • The sensor has almost no pressure loss and extremely low energy loss;
  • Particularly suitable for large diameter pipeline, with low cost advantages.
Technical Specification
Nominal Diameter DN50~DN3000
Electrode Material 316L, Hb, Hc, Ti, Tan
Lining Material PEEK
Dielectric Conductivity ≥20μS/cm
Accuracy Level ±1.5%R~±3.0%R
Flow Range 0.3m/s~10m/s
Ambient Temperature A:≤80℃;B:≤120℃;C:≤180℃(remote-type)
Nominal Pressure 0.6MPa~1.6MPa (Based on the meter size)
Installation Form Compact/Remote
Housing Material Stainlesssteel316or304
Installation Type Disassembling without pressure (Fixed-length model) Disassembling with pressure (Pluggable Model)
Others Same as flange-type

Contact Us

Do you have a question about products? Need quotation? Want feedback from us?

Phone

+31-685420393

Our Location

Flow Meter B.V.

Madrigaalhof 3 2807PL Gouda Netherlands

BTW-Number: NL864826850B01

EORI-Number: NL864826850

KvK Number: 88930440

Copyright © By FM 2020.